Chain elevators

It can be used where safety and capacity is required. The chain conveyor is a simple and fail-safe solution for conveying a large amount of grain vertically and at an angle. The conveyor needs an extremely small place. The chain conveyor consists of massive steel construction, it is dust-free and needs little maintanence. It has long life because of its high qualified bearing.

Characteristics:

  • Galvanized surface
  • The lower sprocket consists of two parts therefore the outage.
  • Because of the wide range of products the chain conveyor can be assemblied in many ways according to the demands.
  • The discharging angle can be raked in 45o
  • There is a double house at the driving.
  • The lengthening elements will be galvanized after welding
More information

Fields of end-use:

It is ideal because of its small sizes, it can be mounted where vertical or leaning conveying is needed. It can be used indoor and outdoor.

Basic equipment

The length of the conveyor can be 3-18 m. It has two types: SE-25 and SE-40, which have different capacity and size.

The elements of the chain conveyor: :

  • an elevator head
  • V-belt
  • an elevator leg with an inlet
  • lengthening (2m) with a maintaining hole
  • lengthening from 12,5cm to 2m (every element with a ball chain and rubber sheet)
  • 2 loading wing

The sizes of the concrete inlet

lancosfelvbetongarat


SE-25 one-sided inlet two-sided inlet
without a propeller 6 t 12 t
with a propeller 10 – 20 –
trough
side D=90 mm 9 – 18 –
auger D=135 mm 18- 25 –

SE-40 one-sided inlet two-sided inlet
without a propeller 12 t 24 t
with a propeller 20 – 40 –
trough d=135 mm
side-auger 20 – 40 –

Capacity / hour

Barley, humidity 17%.

Flowing aside

At the trough it is needed to fill with pebbles then the corners of it can be cleaned. At the side channels 5 cm air is needed at the end of it.


lancfelv1 lancfelv2 lancfelv3
Picture 1: back inlet Q20 fixed in the elevator directly Picture 2: a propeller with bolts to the side auger. It is without a deviator or with a hand valve. The propeller can be right or left. Picture 3: A chassis with mounting height, with a rake 45̊ for the chain conveyor.
lancfelv4 lancfelv5 lancfelv6
Picture 4: A trough of the side auger 90, 135, right, left Picture 5: An inlet into the elevator leg for OK160 or Jacob 150.

Motors

SE-25


The total height of the elevator of the motor (m) motor 2 propellers motor motor side auger 90 motor side auger 135
3,5 – 5,5 2,2 kW 0,15 kW pr.m 0,25 kW
6,5 – 8,5 3,0 kW 0,15 kW pr.m 0,25 kW
9,5 – 11,5 4,0 kW 0,15 kW pr.m 0,25 kW
12,5 – 15,5 5,5 kW 0,15 kW pr.m 0,25 kW

lancfelvrajz

lancos_felv_pic_3